تخطي إلى التنقل الرئيسي تخطي إلى البحث تخطي إلى المحتوى الرئيسي

Corrosion inhibition of Ti-6Al-4V alloy in sulfuric and hydrochloric acid solutions using inorganic passivators

  • A. S. Mogoda*
  • , Y. H. Ahmad
  • , W. A. Badawy
  • *المؤلف المقابل لهذا العمل
  • Chemistry Department
  • Cairo University

نتاج البحث: Article › مراجعة النظراء

23 اقتباسات (Scopus)

ملخص

The effect of iodate (IO3-), metavanadata (VO 3-) and molybdate (MoO42-) anions on the passivation of Ti-6Al-4V alloy in sulfuric and hydrochloric acid solutions was studied using open-circuit potential measurements, polarization techniques and electrochemical impedance spectroscopy (EIS). The alloy surface was examined by scanning electron microscopy (SEM). It was found that an optimum concentration of the passivator is essential for the corrosion inhibition process. Above this concentration the rate of alloy corrosion decreases as the concentration of the passivating ion increases. Scanning electron micrographs have shown that the flawed regions present in the alloy surface were repaired in the presence of the passivator anion. The optimum concentration of each anion and its corrosion inhibition efficiency for titanium and Ti-6Al-4V alloy have been determined. It turned out that the corrosion inhibition efficiencies of IO3-, VO3- and MoO4 2- anions for the corrosion of Ti and Ti-6Al-4V in both hydrochloric and sulphuric acid solutions exceed 98%.

اللغة الأصليةEnglish
الصفحات (من إلى)449-456
عدد الصفحات8
دوريةMaterials and Corrosion
مستوى الصوت55
رقم الإصدار6
المعرِّفات الرقمية للأشياء
حالة النشرPublished - يونيو 2004
منشور خارجيًانعم

بصمة

أدرس بدقة موضوعات البحث “Corrosion inhibition of Ti-6Al-4V alloy in sulfuric and hydrochloric acid solutions using inorganic passivators'. فهما يشكلان معًا بصمة فريدة.

قم بذكر هذا