Skip to main navigation Skip to search Skip to main content

Influence of LED irradiance on flexural properties and Vickers hardness of resin-based composite materials

  • G. S. Bhamra
  • , G. J.P. Fleming*
  • , B. W. Darvell
  • *Corresponding author for this work
  • Materials Science Unit
  • Trinity College Dublin
  • The University of Hong Kong

Research output: Contribution to journal › Article › peer-review

18 Scopus citations

Abstract

Objective: To investigate the effect of irradiance through choice of LED light-curing unit (LCU) and fiber-optic tip on the mechanical properties of methacrylate resin-based composites (RBCs). Methods: Rectangular bar-shaped specimens (25 mm × 2 mm × 2 mm) of four RBCs, irradiated from one side for the manufacturer's recommended times with one of two LED LCUs, and with either 8 or 13 mm tip diameter, were tested in three-point bend for flexural strength and modulus of elasticity; Vickers hardness was measured on top and bottom surfaces, on overlapped and non-overlapped irradiation sites. The effects and interactions of all factors were examined by analysis of variance. Results: While the materials tested differed significantly for all properties (P < 1 × 10-6), there was no significant effect for LCU, tip, or irradiance for flexural strength or modulus of elasticity. For hardness, the only significant effect overall was due to irradiance on the bottom surface. Conclusions: Both LCUs and both tips could be used to give adequate top surface hardness, but the recommended maximum increment thickness is too great for adequate cure at the bottom with the tested LCUs at the recommended times. An extended experimental design would be valuable to test behavior at much elevated irradiances.

Original languageEnglish
Pages (from-to)148-155
Number of pages8
JournalDental Materials
Volume26
Issue number2
DOIs
StatePublished - Feb 2010
Externally publishedYes

Keywords

  • Flexure modulus
  • Light-curing unit
  • Three-point flexure strength
  • Vickers hardness

Fingerprint

Dive into the research topics of 'Influence of LED irradiance on flexural properties and Vickers hardness of resin-based composite materials'. Together they form a unique fingerprint.

Cite this