Skip to main navigation Skip to search Skip to main content

The influence of hygroscopic expansion of resin supporting dies on the fracture resistance of ceramic restorations during thermal cycling

  • Qiulan Li
  • , Ni Zhan
  • , Takkun Ng
  • , Michael V. Swain
  • , Boyang Wan
  • , Yutao Jian*
  • , Xiaodong Wang
  • , Ke Zhao
  • *Corresponding author for this work
  • Sun Yat-Sen University
  • Guangdong Provincial Key Laboratory of Stomatology
  • Don State Technical University
  • The University of Sydney
  • Sch. Aerosp., Mech./Mechatronic Eng.
  • Institute of Stomatological Research

Research output: Contribution to journal › Article › peer-review

12 Scopus citations

Abstract

Objectives: To evaluate the hygroscopic expansion characterization of resin composite dies during thermal cycling, and their influence on the fracture resistance of dental ceramic materials as well as the effect of pre-immersion on these measurements. Methods: Disc-shaped specimens (φ = 15.0 mm, h = 1.2 mm) and anatomical crown dies of four resin composites (epoxy, Z350, P60, G10) were fabricated. Disc-shaped samples were continuously soaked in distilled water and the volume expansion was measured at different time point by Archimedes method. Disc-shaped samples were pre-immersed for 0, 7, or 30 days, elastic modulus and hardness were measured using Nanoindentation test; thermal cycling (TC) test was performed (5 °C-55 °C, 104 cycles), and volume expansion during TC was measured. Four kinds of resin die with pre-immersion for 0, 7, or 30 days were cemented to 5Y-Z crown, or epoxy dies without pre-immersion were cemented to 5Y-Z, 3Y-Z and lithium disilicate glass (LDG) crowns, and load-to-failure testing was performed before and after TC. Finite element analysis (FEA) and fractography analysis were also conducted. Results: The hygroscopic expansion was in the order: epoxy > Z350 > P60 > G10. Except for G10, the other three resin composites exhibited different degrees of hygroscopic expansion during TC. Only the elastic modulus and hardness of epoxy decreased after water storage. However, only the fracture loads of 5Y-Z and LDG crowns supported by epoxy dies were significantly decreased after TC. FEA showed a stress concentration at the cervical region of the crown after volume expansion of the die, leading to the increase of the peak stress at the crown during loading. Significance: Only the hygroscopic expansion of epoxy dies caused by TC led to the decrease in the fracture resistance of the 5Y-Z and LDG crown, which may be related to the decrease in the elastic modulus of the epoxy die and the tensile stress caused by it.

Original languageEnglish
Pages (from-to)1231-1243
Number of pages13
JournalDental Materials
Volume40
Issue number8
DOIs
StatePublished - Aug 2024
Externally publishedYes

Keywords

  • Fracture resistance
  • Hygroscopic expansion
  • Resin die
  • Thermal cycling
  • Zirconia

Fingerprint

Dive into the research topics of 'The influence of hygroscopic expansion of resin supporting dies on the fracture resistance of ceramic restorations during thermal cycling'. Together they form a unique fingerprint.

Cite this